Product characteristics.
Averd Co., Ltd. specializes in power-saving lighting based on unique stabilizer technology.
special features
Product Features
Smart Dimming System
With the advantage of extending the lamp life with power saving during dimming, the following three dimming methods can be used depending on the application.
Types of dimming methods.
1. Auto schedule dimming.
Utilization of simultaneous lighting features of streetlights.
Input the dimming program into the stabilizer.
Main applications :
Streetlights, outdoor parking lot lights.
2. Motion sensor dimming.
Maximum brightness with sensor detection.
In case of no detection, minimum brightness is kept.
Main applications :
Indoor parking lot, warehouse, aisle.
3. Central control dimming.
On/off control by light or zone.
Possible to control the brightness individually.
Main applications :
Streetlights, factory lights, intelligent buildings
Auto Schedule Dimming
The most economical dimming system
Main uses :
Streetlights / Outdoor parking lot lights / Landscape lighting
Programmable microcomputer built-in.
A microcomputer is embedded in the stabilizer, so an automatic control program can be input.
In addition, dimming curves can be selected using the built-in dip switch.
Schedule dimming time table.
Examples of 3 types of auto schedule dimming curves that can be selected with the dip switch.
* It is recommended to use with the "Distribution board with GPS receiver built-in" where on/off is automatically controlled according to sunrise and sunset.
Motion Sensor Dimming
Major applications : Power-saving lighting for parking lot / interior
65% power saving
Motion sensor dimming type.
Central control type dimming
Main applications : Streetlights / Factory lights / Intelligent Building
The central controller issues a control command to the distribution board using CDMA communication or the Internet, and the on/off control for each light or for each zone using PLC or ZigBee in the distribution board is made.
With two-way communication applied, the failure situation is reported to the central control center.
Communication control diagram